SINAMICS G150 cabinet units have been designed for variable-speed drives in machine building and plant construction.
They have been specially tuned to the requirements of drives with quadratic or constant load characteristics with medium performance requirements without regenerative feedback.
The control accuracy of the sensorless vector control is suitable for most applications, and additional actual speed value encoders are therefore superfluous.
SINAMICS G150 offer an economical drive solution which can be matched to the respective customer requirements by a wide range of components and options.

With lots of innovative functions – all major facts at a single glance

Supply voltages:
3AC 380 to 480 V
3AC 500 to 600 V
3AC 660 to 690 V
Output ranges:
110 to 900 kW
110 to 1000 kW
75 to 2700 kW
Supply systems: TN/TT or IT
Line frequency: 47 to 63 Hz
Output frequency: 0 to 300 Hz
Fixed frequencies: 15 fixed frequencies plus 1 basic frequency, programmable
Skipped frequency bands: 4, programmable
Customer terminal block: Digital inputs/outputs
Analog inputs/outputs
Inputs for motor temperature evaluation
Variable number
Communications interface: PROFIBUS DP as standard
Braking mode: Braking Module optional
Degree of protection: IP20, optionally IP21, IP23, IP54
Type of cooling: Internal fan (forced air cooling)
Noise level : ≤ 72 dB (A) with 50 Hz line frequency
Cabinet system: Rittal TS 8
Conformity: CE
Software functions: – Automatic restart following interruptions in operation as a result of a power failure
– Smooth connection of converter to rotating motor
– Kinetic bufferingAutomatic motor identification for control optimization
– Programmable ramp-up/down times
– Ramp smoothing
Protection functions: Thermal monitoring of motor and power sections
Undervoltage, overvoltage, earth fault, short-circuit, stall prevention
Safety functions: STO, SS1 (Integrated safety functions with drives)
Suitable motors: Induction motors

SINAMICS G150 are ready-to-connect AC/AC converters in a standard control cabinet. A comprehensive range of options permits adaptation to respective requirements. They are available with cabinet widths from 400 mm upwards in intervals of 200 mm, in various degrees of protection up to IP54, and with two design versions.

Version A offers sufficient space for all available options. Different designs permit the power supply and motor connections to be located at the top or bottom. This results in high flexibility for the plant installation.

Version C is an extremely space-saving version envisaged for applications where the power supply components are accommodated in a central low-voltage distribution and need not be provided again in the control cabinet. The user-friendly AOP30 operator panel is fitted as standard in the cabinet door for both versions.